Punch
Overview
Punch holes in the left side of the paper. This function is available for document filing and other purposes.
NOTICE
- Do not punch special paper such as labels or tracing paper. Punching special paper may cause an unexpected failure.
Tips
- The available paper size or number of sheets varies depending on the mounted optional devices. For details, refer to Optional Part Names and Specifications for Paper Output.
- The punched sheets are output to the Main tray.
Tips
- PostInserter PI-502: The Lower tray can be used as a paper tray. The Upper tray is not available.
- FoldingUnit FD-503: The Upper tray can be used as a paper tray. The Lower tray is not available.
Specifications
Category | Print Workflow | ||
Location | Machine | Control Panel | |
Printer driver | - | ||
Application | - | ||
Required options | This function requires one of the following optional devices. Finisher FS-541 with PostInserter PI-502 and Punch Unit PK-525 mounted FoldingUnit FD-503 | ||
Required items | - | ||
Setting items | FoldingUnit FD-503 mode selection key  | Selects the desired punch mode. PostInserter PI-502: Only 2-Hole Punch can be selected. FoldingUnit FD-503: The following punch holes can be selected. Metric area: 2-Hole Punch, 3-Hole Punch Inch area: 2-Hole Punch, 4-Hole Punch Sweden: Swedish 4-Hole Punch | |
Mode selection LED of PostInserter PI-502:  Mode selection LED of FoldingUnit FD-503:  | Punches hole in paper. This LED lamp lights up when the Punch mode is selected. | ||
Start/Stop key  | Starts or stops processing. | ||
Remarks | 4-Hole Punch for Sweden: Available only for Sweden. | ||
Reference | - | ||
Screen access | - | ||
Procedure (for PostInserter PI-502)
1
Load paper into the Lower tray of PostInserter PI-502, and align the Side guides with the paper.
Load paper with the front side up.
Punch holes at the rear edge of the loaded paper.
2
Press the Punch key [1] on the Post inserter control panel to turn on the LED lamp.
Punch holes can be combined with Corner Staple or 2 Position Staple.
3
Press the Start/Stop key [3] to start processing.
Procedure (for FoldingUnit FD-503)
1
Load paper into the Upper tray of Post inserter of FoldingUnit FD-503, and align the Side guides with the paper.
Load paper with the front side up.
Punch holes at the rear edge of the loaded paper.
2
Press the Punch selection key [2] on the Post inserter control panel to turn on the selected Punch mode LED lamp.
Punch holes can be combined with Corner Staple or 2 Position Staple.
3
Press the Start/Stop key [1] to start processing.
If the machine stops because double feeding was detected but did not actually occur, press Multi-feed detection key [2] to light up the Double Feed Detection OFF indicator LED.
To stop processing, press Start/Stop key [1] again.
in the upper-right of a page, it turns into 
and is registered as a bookmark.